The decal with the larger Order value is set on top of the other ones. Order – Specifies a layering order when multiple VRayDecal gizmos are present. ![]() The maximum fade out angle is 180 and it can't take values less than the Normal angle. Values closer to the Normal angle produce a sharper gradient. See the Fade Out Angle example below.įade out angle – Specifies the angle which creates a fadeout gradient starting from the Normal angle. Normal angle – Specifies the angle to which the decal is applied onto the surface below.įade out – Enables the use of a fade out angle. This parameter can take values below 0 and above 100. Projection offset % – Specifies the offset of the VRayDecal gizmo in percentages. Projection depth – Specifies the depth of the volume in which the image is projected. ![]() Note that procedural textures are ignored. Length – Specifies the length of the VRayDecal gizmo.įit aspect ratio to bitmap – Оpens a browser window where a bitmap image can be selected and used to resize the VRayDecal based on that bitmap aspect ratio.įit aspect ratio to material – Resizes the VRayDecal to match the aspect ratio of the first eligible texture (bitmap) in the assigned material. Width – Specifies the width of the VRayDecal gizmo. Preview – When enabled, a preview of the material assigned to the VRayDecal is shown in viewport.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |